Revision 1.63

Back to VTube-LASER

The Report menu was redesigned so that operators choose from a list of report templates to show any one of several reports.

• Give each report template a name that is linked to an external report template file.
  
  
• Change the list (Add, Delete, Move the template up or down).
  
  
• Edit any template in the included Notepad++ editor (installs with v1.63).
  
  
• Explore the folder that contains the templates.
  
  
• There is no limitation on the number of templates allowed.
  
  
• The report template setup is stored local to the computer (not in project files).
  
  

The Report menu was redesigned so that operators choose from a list of report templates to show any one of several reports.

• Give each report template a name that is linked to an external report template file.
  
  
• Change the list (Add, Delete, Move the template up or down).
  
  
• Edit any template in the included Notepad++ editor (installs with v1.63).
  
  
• Explore the folder that contains the templates.
  
  
• There is no limitation on the number of templates allowed.
  
  
• The report template setup is stored local to the computer (not in project files).
  
  

• Updated the graphics engine for faster redraws.
  
  
• Added more report values - master length, measured length, delta between measured and master, bender setup LRA
  
  
• Updated the manual and help file.
  

VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points.

A new End-Scan Fit window gives information about how many points were used in the end-trim, and the span of all the point positions. Higher point counts with lower spans indicate a better data set for end-trim.

• The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified. This has been resolved in this version.

• No known issues

VTube-LASER Training Video - How to perform effective end scans.