Difference between revisions of "Change the default linear units in VTube"
From ATTWiki
| Line 42: | Line 42: | ||
</td> | </td> | ||
</tr> | </tr> | ||
| + | |||
<tr> | <tr> | ||
<td width=300> | <td width=300> | ||
Exit the System Options menu. VTube will now clear to the new linear unit. | Exit the System Options menu. VTube will now clear to the new linear unit. | ||
| + | </td> | ||
<td> | <td> | ||
</td> | </td> | ||
</tr> | </tr> | ||
| + | |||
</table> | </table> | ||
<br> | <br> | ||
Revision as of 13:44, 25 May 2011
|
Revision 1.65
|
|
Steps to changing the default linear units
| Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active. |
|
| Press the System Options button. |
|
| Press the Project Setup tab, and then press the Set Project Default State button. |
|
|
Exit the System Options menu. VTube will now clear to the new linear unit. |
Other Pages
- Back to the VTube page
