Difference between revisions of "CNC Bender v12-20110525"

From ATTWiki
Jump to: navigation, search
(→‎25px ENHANCED - Changes)
(→‎25px ENHANCED - Changes)
Line 17: Line 17:
  
  
−
===[[image:Check.jpg|25px]] ENHANCED - Changes  ===
+
===[[image:Check.jpg|25px]] ENHANCED - Changes to Logic ===
  
 
<table cellpadding=10>
 
<table cellpadding=10>

Revision as of 02:34, 26 May 2011

v12-20110525

Cncv12procontrol withteachmode.jpg



Check.jpg ENHANCED - Changes to Logic

  • Chuck Close/Open Skip in Post Bend - for special teach mode unloading

  • Processor checks for special internal command in processlists - which is required even in custom processlists: [BEGIN RUN AGAIN]

  • Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed.



Check.jpg NEW - SmartInspect Configuration File Added

A new configuration file "loggingsetup.cfg" is added to the cnc\config folder.

The new logging setup allows for debug logging in both CNC Processor and CNC Bender.

The logging setup features for CNC Processor were previously in the CNCProcessor.cfg file.

Logginsetup file.jpg



Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12-20110525&oldid=16535"