Revision as of 01:41, 4 November 2011

v12-20111103

A high speed timer in CNC Processor was adjusted so that it would run properly with thread synchronization to prevent access errors.

@@ Line 22: / Line 22: @@
 <td width=300>
-</td>
-</tr>
-</table>
-===[[image:Check.jpg|25px]] NEW - "Pulse Enable At Halt" in Axis List Setup  ===
-<table cellpadding=10>
-<tr valign=top>
-<td width=400>
-"Pulse Enable At Halt=" is a new parameter in the axis list configuration.<br><br>
-This allows you to setup CNC Bender to always pulse the enable of an axis during the HALT command.<br><br>
-This makes the axis super safe because it always clears all following error.
-</td>
-<td width=300>
-The default value is "1" which means "true" or "enabled."  Use 0 to switch this feature off.
-</td>
-</tr>
-</table>
-===[[image:Check.jpg|25px]] NEW - "Enable Only To Move" in Axis List Setup  ===
-<table cellpadding=10>
-<tr valign=top>
-<td width=400>
-"Enable Only To Move=" is a new parameter in the axis list configuration.<br><br>
-This allows you to setup CNC Bender to enable axes only when in motion.<br><br>
-</td>
-<td width=300>
-The default value is "0" which means "disabled."  Use 1 to switch this feature on.
 </td>