Difference between revisions of "CNC Bender v12-20111130"

From ATTWiki
Jump to: navigation, search
(→‎25px New - [Enable Axis] Internal Command)
(→‎25px New - [Enable Axis] Internal Command)
Line 52: Line 52:
 
<td width=300>
 
<td width=300>
 
</td>
 
</td>
−
 
−
 
 
</tr>
 
</tr>
 
</table>
 
</table>
−
 
  
 
===[[image:Check.jpg|25px]] Other  ===
 
===[[image:Check.jpg|25px]] Other  ===

Revision as of 21:44, 30 November 2011

v12-20111130

Cncv12procontrol withteachmode.jpg

Check.jpg ENHANCED - PDA Motion in Test Bend

  • The PDA gearing is now properly set if the VG (Realtime Variable Gearing) feature is off or on.

  • The PDA returns home when the operator presses All Dies Home.

Check.jpg REPAIR - Tube Support During Home

  • The Tube Support now stays DOWN during homing when the tube support UP enable feature is disabled.

Check.jpg New - [Enable Axis] Internal Command

  • This command is used by the process list builder to enable the Feed axis even when the axis list is setup to only enable when moving. This ensures that the Feed axes with low gearbox ratios stay in position when loading the tube.

Check.jpg Other

  • Fixed the labeling in some of the general dynamic options.

  • Removed the halt after every jog command in order to allow gearing settings to hold after setup jogs.

Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12-20111130&oldid=17189"