Difference between revisions of "CNC Bender v12-20111229"
From ATTWiki
| Line 19: | Line 19: | ||
<td width=400> | <td width=400> | ||
* The pressure die interference logic would stop the bending with a collision fault if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. | * The pressure die interference logic would stop the bending with a collision fault if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. | ||
| + | <br><br> | ||
* This has been resolved with this version. If the PDA is a servo axis, then the potential for collision is ignored. | * This has been resolved with this version. If the PDA is a servo axis, then the potential for collision is ignored. | ||
Revision as of 18:00, 29 December 2011
v12-20111229
|
|
REPAIR - Pressure Die Interference Zone
|
|
Other
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
