Revision as of 18:01, 29 December 2011

v12-20111229

The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.

This has been resolved with this version. If the PDA is a servo axis, then the potential for collision is ignored.

Revision as of 18:01, 29 December 2011 (view source) Mcone (Talk \| contribs) (→‎25px REPAIR - Pressure Die Interference Zone Collision Message) ← Older edit		Revision as of 18:01, 29 December 2011 (view source) Mcone (Talk \| contribs) (→‎25px Other) Newer edit →
Line 32:		Line 32:
	</table>		</table>

−	~~===[[image:Check.jpg\|25px]] Other ===~~