Difference between revisions of "CNC Bender v12-20111229"

From ATTWiki
Jump to: navigation, search
(→‎25px REPAIR - Pressure Die Interference Zone Collision Logic Change)
(→‎25px REPAIR - Pressure Die Interference Zone Collision Logic Change)
Line 21: Line 21:
 
<br>
 
<br>
 
* THE REPAIRED LOGIC: Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored .  This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm.
 
* THE REPAIRED LOGIC: Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored .  This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm.
−
<br>
+
 
−
* Note that it is possible for a collision to still occur if the radius value is set too large in the tool page, or the real-time variable gearing for the PDA is set low enough to allow the carriage to catch up to the PDA.
+
 
</td>
 
</td>
  

Revision as of 18:55, 29 December 2011

v12-20111229

Cncv12procontrol withteachmode.jpg

Check.jpg REPAIR - Pressure Die Interference Zone Collision Logic Change

  • ISSUE: The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.


  • THE REPAIRED LOGIC: Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored . This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm.


Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12-20111229&oldid=17363"