Difference between revisions of "VTube-LASER v1.76.3"
From ATTWiki
| Line 22: | Line 22: | ||
VTube-LASER can now automatically damp correction data in order to avoid oversteer.<br><br> | VTube-LASER can now automatically damp correction data in order to avoid oversteer.<br><br> | ||
[[image:vtube-autocorrectiondamping_options.jpg|300px]] | [[image:vtube-autocorrectiondamping_options.jpg|300px]] | ||
| + | <br><br> | ||
| + | Two adjacent 90 degree bends that are close to each other followed by a long straight causes VTube (and other measuring solutions) to overcorrect the end of the long straight. The end is supposed be corrected to the middle straight (the MASTER) like this: | ||
| + | |||
| + | [[image:vtube-automatic_proper_correction_tube_swing.jpg|300px]] | ||
| + | |||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
Revision as of 00:36, 4 April 2012
|
Revision 1.76.3Back to VTube-LASER |
|
NEW: Automatic Damping for Correction
|
VTube-LASER can now automatically damp correction data in order to avoid oversteer.
|
|
Enhanced: Bender Setup Window Redesigned
|
VTube-LASER's Bender Setup menu was redesigned to fit more options into the window. |
Other Pages
- Back to VTube-LASER
