Difference between revisions of "CNC Bender v12-20120629"

From ATTWiki
Jump to: navigation, search
(25px Repair - Default Option Values in the Toolbox Now Switched Off)
(25px Repair - Default Option Values in the Toolbox Now Switched Off)
Line 13: Line 13:
 
</table>
 
</table>
 
__NOTOC__
 
__NOTOC__
===[[image:Check.jpg|25px]] Repair - Default Option Values in the Toolbox Now Switched Off===
+
===[[image:Check.jpg|25px]] Repair - Processlist Builder Proper Tracking of Option in or out of Toolbox===
  
 
<table cellpadding=10>
 
<table cellpadding=10>

Revision as of 00:46, 30 June 2012

v12-20120629

Cncv12procontrol withteachmode.jpg

Check.jpg Repair - Processlist Builder Proper Tracking of Option in or out of Toolbox

By default, dynamic options should be OFF or in their DEFAULT state when in a Toolbox.

However, the CNC Processlist Builder improperly tracked if an option was inside the toolbox. This sometimes caused hard-to-trace side-effects where an option seemed to be OUT of the Toolbox to Processlist Builder, but was inside the Toolbox in CNC Bender. Unintended effects could be as serious as skipping bends for example.

This version fixes this issue by allowing both CNC Bender, CNC Processlist Builder and CNC Processor to track if the operator has placed the option in the Toolbox based on which operator station the part is running in.

Check.jpg Repair - Robot Clear Bit Can Be High or Low

The Robot Clear bit always assumed that the TRUE signal was bit high. But some machines assume the opposite. This has been fixed.

Other Pages