Difference between revisions of "VTube-STEP v1.77.3"
From ATTWiki
| Line 64: | Line 64: | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Revision as of 03:14, 8 August 2012
|
Revision 1.77.3
|
|
UPDATED: View Orientation Control
|
The View Orientation Control has new choices with graphics icons of each axes orientation. |
|
NEW: End Lengths Change in Diameter Model with End Adjustment Length Values
| When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location. |
REPAIR: Cut Length Calculation with End Adjustments
| The End Length Adjustments were doubled in the Cut Length calculation. This is repaired in this version. |
|
ENHANCED: TubeCalc Project Imports Include More Values
The following values were added to TubeCalc imports in this version:
| From TubeCalc | To VTube | |
| Customer Name |  | Customer |
| Material Name | | Material Spec |
| User | | Author |
| Material Offset 1 | | A-End Length Adjust |
| Material Offset 2 | | B-End Length Adjust |
| Measuring Center Offset A | | A-End Measured Offset |
| Measuring Center Offset B | | B-End Measured Offset |
FIXED: Projection Tolerances Now Change Units Properly
|
The projection tolerance now handles a change in linear units properly. |
|
ENHANCED: Report Formatting Updated
|
The report formatting is updated with larger and bolder tiles. |
|
Other Pages
- Back to the VTube page
