Difference between revisions of "VTube-STEP v1.77.3"
From ATTWiki
| Line 18: | Line 18: | ||
| − | ===[[image:Check.jpg|25px]] | + | ===[[image:Check.jpg|25px]] ENHANCED: View Orientation Control Redesigned=== |
[[image:vtube_1.77.3_vieworientation_closeup.jpg|250px]] | [[image:vtube_1.77.3_vieworientation_closeup.jpg|250px]] | ||
<table cellpadding=10> | <table cellpadding=10> | ||
Revision as of 03:21, 8 August 2012
|
Revision 1.77.3
|
|
ENHANCED: View Orientation Control Redesigned
|
The View Orientation Control has new choices with graphics icons of each axes orientation. |
NEW: End Lengths Change in Diameter Model with End Adjustment Length Values
| When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location. |
REPAIR: Cut Length Calculation with End Adjustments
| The End Length Adjustments were doubled in the Cut Length calculation. This is repaired in this version. |
Other Pages
- Back to the VTube page
