Difference between revisions of "VTube-STEP v1.77.3"
From ATTWiki
| Line 26: | Line 26: | ||
You can click on the button or the image to find a new orientation.</td> | You can click on the button or the image to find a new orientation.</td> | ||
<td width=300> | <td width=300> | ||
| + | [[image:vtube_1.77.3_vieworientation.jpg|150px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
===[[image:Check.jpg|25px]] NEW: End Lengths Change in Diameter Model with End Adjustment Length Values=== | ===[[image:Check.jpg|25px]] NEW: End Lengths Change in Diameter Model with End Adjustment Length Values=== | ||
Revision as of 03:21, 8 August 2012
|
Revision 1.77.3
|
|
ENHANCED: View Orientation Control Redesigned
|
The View Orientation Control has new choices with graphics icons of each axes orientation. |
|
NEW: End Lengths Change in Diameter Model with End Adjustment Length Values
| When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location. |
REPAIR: Cut Length Calculation with End Adjustments
| The End Length Adjustments were doubled in the Cut Length calculation. This is repaired in this version. |
Other Pages
- Back to the VTube page
