Difference between revisions of "Benderlink Ethernet Module"
From ATTWiki
(→Why is it needed?) |
|||
| Line 3: | Line 3: | ||
===Why is it needed?=== | ===Why is it needed?=== | ||
| − | The Benderlink wireless device module is used with benders that use the RS-232 protocol for communications. The device allows RS-232 signals to be converted into either encyrpted WiFi or WIRED TCP/IP signals. | + | The Benderlink wireless device module is used with benders that use the RS-232 protocol for communications. The device allows RS-232 signals to be converted into either encyrpted WiFi or WIRED TCP/IP signals. |
| + | |||
| + | This overcomes the distance limitations inherent to RS-232 (max of 50 feet). RJ-45 cables transferring ethernet, have a distance limitation of ''over'' 300 feet between switches. Wireless distance limitations vary with the characteristics of the plant setup. A typical max distance for wireless is 100 to 150 feet. | ||
===Which Benders Use It?=== | ===Which Benders Use It?=== | ||
Revision as of 21:35, 28 July 2006
Why is it needed?
The Benderlink wireless device module is used with benders that use the RS-232 protocol for communications. The device allows RS-232 signals to be converted into either encyrpted WiFi or WIRED TCP/IP signals.
This overcomes the distance limitations inherent to RS-232 (max of 50 feet). RJ-45 cables transferring ethernet, have a distance limitation of over 300 feet between switches. Wireless distance limitations vary with the characteristics of the plant setup. A typical max distance for wireless is 100 to 150 feet.
Which Benders Use It?
Currently the benders that we can support using this module are:
- Chiyoda
- Keins
- MiiC
- Eaton Leonard (The EL benders require this device and an embedded computer.)
--Mcone 17:32, 28 July 2006 (EDT)
