v12-20130722

• Back to CNC Bender Software Updates

This new feature allows selected COMDEFs to run in the processlist without pausing during CYCLE HOLD. The reason for this new capability is that some customers require that their benders be equipped with palm buttons that must be held during any part of the bending with pinch-point motion.

For example, the Allen Bradley 800Z Zero Force Touch Buttons can be installed on the left and right side of control.

There are points in the cycle where it is necessary to grasp the part and open the dies to remove the part from the bender. However, removing hands from the touch buttons to remove the part puts the part into cycle hold. The commands that examine the RELEASE button and open the dies can be programmed to ignore CYCLE HOLD in order to open the dies in CYCLE HOLD.
<br Another benefit of this capability is that many commands that wait, illuminate, or set outputs without moving actuators can be working even during CYCLE HOLD. This speeds the process by letting the non-motion commands to continue to run.

The COMDEF Editor allows setup technicians to indicate which COMDEFs can safely ignore CYCLE HOLDS

• This version of CNC Bender has a decreased input check time from 125 ms to 16 ms for faster response time.
  
  
• Repaired a logic issue with BEGIN condition inputs that would cause Commands to show incompleted inputs when they were completed.
  
  
• The input for Master Power ON can now be either a BEGIN or END style input.
  
  
• The input for Safety Relay ON can now be either a BEGIN or END style input.