Difference between revisions of "CNC Bender v12.1.1"

From ATTWiki
Jump to: navigation, search
(→‎25px FIX: FRB Clear Part Fixed)
(→‎25px NEW: "Store Jog Commands When In Cycle Hold" Option)
Line 29: Line 29:
 
</table>
 
</table>
  
−
===[[image:Check.jpg|25px]] NEW: "Store Jog Commands When In Cycle Hold" Option===
+
===[[image:Check.jpg|25px]] NEW: Processor Now Checks to See if Inputs are Internal===
 
<table cellpadding=10>
 
<table cellpadding=10>
 
<tr valign=top>
 
<tr valign=top>
 
<td width=300>
 
<td width=300>
−
A new low-level option is added that changes the behavior of motion-controlled Jog commands when the control is in Cycle Hold.  The "Store Jog Commands When In Cycle Hold" command will allow the bender to store and act on any jog command that was pressed immediately after entering CYCLE START.<br><br>
+
CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.<br><br>
−
If the feature is disabled, then CNC BENDER will not store motion-controlled jog commands - but will clear them from the queue.<br><br>
+
 
</td>
 
</td>
 
<td width=300>
 
<td width=300>

Revision as of 15:50, 14 August 2013

v12.1 - August 14, 2013

Cncv12procontrol withteachmode.jpg


See CNC Bender Customer Service Page for an update.

Check.jpg FIX: FRB Clear Part Fixed

CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder.

Check.jpg NEW: Processor Now Checks to See if Inputs are Internal

CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.

Check.jpg Other Changes

Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12.1.1&oldid=22855"