Difference between revisions of "CNC Bender v12.1.1"
From ATTWiki
(→v12.1 - August 14, 2013) |
|||
| Line 4: | Line 4: | ||
===v12.1 - August 14, 2013=== | ===v12.1 - August 14, 2013=== | ||
*Back to [[CNC Bender Software Updates]] | *Back to [[CNC Bender Software Updates]] | ||
| + | *See [http://advancedtubular.com/customers/cncbender CNC Bender Customer Service Page] for an update. | ||
</td> | </td> | ||
| Line 15: | Line 16: | ||
__NOTOC__ | __NOTOC__ | ||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] FIX: FRB Clear Part Fixed === | ===[[image:Check.jpg|25px]] FIX: FRB Clear Part Fixed === | ||
Revision as of 15:55, 14 August 2013
v12.1 - August 14, 2013
|
|
FIX: FRB Clear Part Fixed
CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder.
NEW: Processor Now Checks to See if Inputs are Internal
CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.
FIX: CNC Bender Benderlink Fix with Laservision
CNC Bender Benderlink would sometimes return an out-of-bounds error after receiving Laservision data. This was related to setting the first straight adjustment value to zero. It has been resolved.
ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision
Hyprex Laservision
Other Changes
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
