Difference between revisions of "CNC Bender v12.2"
From ATTWiki
(→25px NEW: Feed Adjust Percentage Warnings) |
|||
| Line 56: | Line 56: | ||
==[[image:Check.jpg|25px]] Other Changes == | ==[[image:Check.jpg|25px]] Other Changes == | ||
| + | <table> | ||
| + | <tr> | ||
| + | <td width=400> | ||
* The Prebend Warning page would never display - even if warning data existed. Now it displays immediately after AutoBuild and before entering AUTO mode. | * The Prebend Warning page would never display - even if warning data existed. Now it displays immediately after AutoBuild and before entering AUTO mode. | ||
<br> | <br> | ||
* Manual page Absolute feed moves will now swing away the inside wiper when moving inside the inside wiper zone. | * Manual page Absolute feed moves will now swing away the inside wiper when moving inside the inside wiper zone. | ||
<br><br> | <br><br> | ||
| + | </td> | ||
| + | <td width=300> | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
==Other Pages== | ==Other Pages== | ||
Revision as of 16:51, 25 September 2013
v12.2 - September 27, 2013
|
|
NEW: BendPDAFeed Gearing Option
CNC Bender can now gear the PDA and Feed axis to the Bend arm motion at the same time.
- Enable this option in the Low Level menu.
- The option requires special wiring of the I2T IFC 220E motion cards.
- This option works only with Feed Bending.
- This option will take into account the Feed DISTANCE Adjust percentages in the Tool page and the Bend options. (The adjust percentages in the two locations are added together before being applied to the gearing.)
- This option ignores the Feed SPEED Adjust percentages in the Bend options - because the speed is completely dependent on the gear ratio determined by the arc length plus the adjustment percentages.
- This option is ignored in the Eagle boost bending mode.
NEW: Feed Adjust Percentage Warnings
CNC Bender now issues warnings when the Feed Distance Adjust Percentages total more than 50% in ether the positive or negative direction.
The warning will display after an Autobuild, and require the user to choose to take action.
ENHANCED: CIO Dictionary Editor Utility Added
The CIO Dictionary can now change the module names of given module to a new module name in the utilities menu.
Other Changes
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
