Difference between revisions of "CNC Bender v12.8"
From ATTWiki
(→25px FIXED: Teach Mode and Custom Commands Issue Solved) |
(→25px FIXED: Teach Mode and Custom Commands Issue Solved) |
||
| Line 21: | Line 21: | ||
<tr> | <tr> | ||
<td width=600> | <td width=600> | ||
| + | |||
| + | ..Note: This fix applies only to bender with non-standard axis numbering for the Feed or Rotate axes (that does not match Feed = 1, Rotate = 2).. | ||
| + | |||
Custom commands can be entered after every bend in the FRB page. SMT discovered a that FEED and ROTATE commands would not be completed properly when coming out of a custom move.<br><br> | Custom commands can be entered after every bend in the FRB page. SMT discovered a that FEED and ROTATE commands would not be completed properly when coming out of a custom move.<br><br> | ||
* For example, the ROTATE was programmed at 90 degrees. The custom move is 89 degrees - so the finish up command should be set to 1 degree to come to the full 90. However, the finish-up command was 90 degrees - which caused the rotate to move to 89 + 90 = 179 degrees.<br><br> | * For example, the ROTATE was programmed at 90 degrees. The custom move is 89 degrees - so the finish up command should be set to 1 degree to come to the full 90. However, the finish-up command was 90 degrees - which caused the rotate to move to 89 + 90 = 179 degrees.<br><br> | ||
| − | * This problem occurred on benders where the ROTATE axis is set to a non-standard machine axis 3 | + | * This problem occurred on benders where the ROTATE axis is set to a non-standard machine axis 3 because the machine axis number was hard coded into the process list builder.<br><br> |
* Process list builder now has logic that anticipates that the machine axis number for any motion actuator can change depending on the application. | * Process list builder now has logic that anticipates that the machine axis number for any motion actuator can change depending on the application. | ||
Revision as of 15:09, 28 February 2014
v12.8 - February 1, 2014
|
|
FIXED: Teach Mode and Custom Commands Issue Solved
|
..Note: This fix applies only to bender with non-standard axis numbering for the Feed or Rotate axes (that does not match Feed = 1, Rotate = 2).. Custom commands can be entered after every bend in the FRB page. SMT discovered a that FEED and ROTATE commands would not be completed properly when coming out of a custom move.
|
ENHANCED: Load and Start Positions with Bend Arm Motion Option (in Pre Bend)
|
The Option List panels now clear if all options are placed in the tool box. |
|
Other Changes
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
