Difference between revisions of "VTube-LASER v1.91"
(→25px NEW: Use Leapfrog To Measure Very Long Tubes) |
(→25px NEW: Use Leapfrog To Measure Very Long Tubes) |
||
| Line 31: | Line 31: | ||
A leap can occur at any point during any tube measurement.<br><br> | A leap can occur at any point during any tube measurement.<br><br> | ||
Leapfrog moves are more accurate than using the "Move Tube" command because they rely on more precise conical seats.<br><br> | Leapfrog moves are more accurate than using the "Move Tube" command because they rely on more precise conical seats.<br><br> | ||
| − | [[image:vtube- | + | [[image:vtube-lasesr-1.91-leapfrog-button.png|300px]]<br><br> |
[[image:vtube-lasesr-1.91-leapfrog_points_before_leap.png|400px]]<br><br> | [[image:vtube-lasesr-1.91-leapfrog_points_before_leap.png|400px]]<br><br> | ||
| − | [[image:vtube-lasesr-1.91-leapfrog_points_after_leap.png|400px]] | + | [[image:vtube-lasesr-1.91-leapfrog_points_after_leap.png|400px]]<br><br> |
| − | + | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
| + | [[image:vtube-laser-1.91-faro_magnetic_cones.png]]<br><br> | ||
[[image:vtube-laser-1.91-leapfrog_illustration.png|400px]]<br><br> | [[image:vtube-laser-1.91-leapfrog_illustration.png|400px]]<br><br> | ||
Revision as of 02:06, 25 June 2014
|
Revision 1.91
|
|
- See VTube-LASER Customer Support Page to download the latest version.
NEW: Use Leapfrog To Measure Very Long Tubes
|
The new Leapfrog feature allows you to measure any length of tube by measuring three or more magnetic cones, leaping the cones with the FARO arm, then measuring the cones again - then continuing measuring from where you left off before the leap. |
|
NEW: FARO Calibration Dialogs Now Shows Either Inches or Millimeters
|
Previous versions showed all linear distance values in Millimeters. Some users prefer to view them in Inches, so now the dialogs will show either unit depending on the current unit setting in VTube-LASER. |
|
NEW: Direct Communications with Eaton Leonard Premier, EL2000, and Ve-log Benders
|
|
Enhanced: Project Batch Report Output
|
|
Load the batch reporter in the Report menu of either STEP mode of LASER mode: |
|
This is a sample report file: |
If the batch reporter finds files with 0 or negative length straights, then it will issue a WARNING at the end of the report log and create a second report file containing a list of all the project files with these lengths: |
Other Changes
Other
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER
- See VTube Language Editor
