Difference between revisions of "VTube-STEP v1.94"
(→25px ENHANCED: Automatic Projection Tolerance for Centerline Calculation) |
(→25px ENHANCED: Automatic Projection Tolerance for Centerline Calculation) |
||
| Line 78: | Line 78: | ||
</table> | </table> | ||
| − | ===[[image:Check.jpg|25px]] ENHANCED: | + | ===[[image:Check.jpg|25px]] ENHANCED: DEFAULT Projection Tolerance for Centerline Calculation is Removed from Interface === |
<table cellpadding=10> | <table cellpadding=10> | ||
| Line 90: | Line 90: | ||
</td> | </td> | ||
</tr> | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] CRITICAL ENHANCEMENT: Cylinder Centerline Calculation in Math Engine Improved for Very Rough Cylinders === | ||
| + | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
'''PROJECTION TOLERANCE ACCURACY'''<br><br> | '''PROJECTION TOLERANCE ACCURACY'''<br><br> | ||
| − | + | To enhance the calculations, the automatic Projection Tolerance in VTube-STEP now starts with an much smaller projection tolerance at a 10th of a micron (0.0001 mm, or 0.000003937 inches).<br><br> | |
If the centerline for the cylinders cannot be solved for, then VTube increases the projection tolerance until it finds a solution.<br><br> | If the centerline for the cylinders cannot be solved for, then VTube increases the projection tolerance until it finds a solution.<br><br> | ||
The final projection tolerance used is stored in the Collection grid so that you can view the result at any time after a calculation. | The final projection tolerance used is stored in the Collection grid so that you can view the result at any time after a calculation. | ||
Revision as of 17:20, 29 August 2014
|
Revision 1.94
|
|
- See VTube-STEP Customer Support Page to download the latest version.
NEW: Trim Surface Datum for Trimming or Extending End Lengths
|
VTube-STEP now allows for different kind of Trim Surfaces now. Older versions only allow for the centroid (average XYZ point) of all points in a solid used to trim. |
|
|
|
|
|
|
|
NEW: Add Collection Grid Properties Column and Edit Datum Menu
|
The new properties column allows for new options to accompany each of the collected objects. Right click on any TrimSurf row, then choose Edit Trim Surface Datum to enter this menu (below): |
|
ENHANCED: DEFAULT Projection Tolerance for Centerline Calculation is Removed from Interface
|
Since the STEP mode calculation engine completely automates the Projection Tolerance, there is no longer a need for the user to set this value. |
|
CRITICAL ENHANCEMENT: Cylinder Centerline Calculation in Math Engine Improved for Very Rough Cylinders
|
PROJECTION TOLERANCE ACCURACY |
|
Other Changes
|
Other Pages
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER
