Difference between revisions of "How To Calculate Cut Lengths in VTube"
From ATTWiki
(→XYZ Intersection +/- Tolerance Values in Printed Reports) |
(→How to Remove Elongation From the Cut Length) |
||
| Line 31: | Line 31: | ||
</table> | </table> | ||
| − | == How to Remove Elongation From the Cut Length == | + | == How to Calculate and Remove Elongation From the Cut Length == |
<table cellpadding=10> | <table cellpadding=10> | ||
| Line 38: | Line 38: | ||
VTube also uses the Tube Elongation Percentage value to remove anticipated elongation.<br><br> | VTube also uses the Tube Elongation Percentage value to remove anticipated elongation.<br><br> | ||
The more positive the value the more elongation is removed from the cut length. A typical value is between 3 and 5 (percent).<br><br> | The more positive the value the more elongation is removed from the cut length. A typical value is between 3 and 5 (percent).<br><br> | ||
| + | Recalculate the Cut Length for the tube elongation percentage to take effect. | ||
<br><br> | <br><br> | ||
</td> | </td> | ||
Revision as of 20:51, 22 September 2014
|
|
|
Calculating Cut Length in the Part Setup Menu
|
You can calculate the cut length of the tube in the Part Setup menu in either STEP or LASER modes. To calculate the cut length, right click on the Part Setup menu, and choose "Calculate Cut Length".
|
|
How to Calculate and Remove Elongation From the Cut Length
|
VTube also uses the Tube Elongation Percentage value to remove anticipated elongation. |
|
Other Pages
- Back to VTube-LASER
