Difference between revisions of "VTube-LASER v1.99"
From ATTWiki
(→25px ENHANCEMENT: "Pull Arm from Cradle" Message Removed for Automatic Scan Modes) |
(→25px ENHANCEMENT: "Pull Arm from Cradle" Message Removed for Automatic Scan Modes) |
||
| Line 29: | Line 29: | ||
So now VTube only displays the message if the scanner is setup in the VTube Project file for FIXED mode. | So now VTube only displays the message if the scanner is setup in the VTube Project file for FIXED mode. | ||
</td> | </td> | ||
| + | <td width=500> | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] NEW: CSM M4 and Alpine M4 Bender Correction=== | ||
| + | |||
| + | <table cellpadding=10 width=800> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | The two bender formats - Alpine and CSM M4, were added to VTube-LASER.<br><br> | ||
| + | This allows VTube-LASER to correct either control in a full bi-directional corrections loop.</td> | ||
<td width=500> | <td width=500> | ||
</td> | </td> | ||
Revision as of 01:14, 26 November 2014
|
Revision 1.99
|
|
ENHANCEMENT: "Pull Arm from Cradle" Message Removed for Automatic Scan Modes
|
The message is of no value when the arm is running in automatic scan mode. It should only display when the scan algorithm is set to FIXED. This saves confusion for arm users that always use AUTOMATIC modes. So now VTube only displays the message if the scanner is setup in the VTube Project file for FIXED mode. |
NEW: CSM M4 and Alpine M4 Bender Correction
|
The two bender formats - Alpine and CSM M4, were added to VTube-LASER. |
Other
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER
- See VTube Language Editor
