Difference between revisions of "VTube-STEP v2"
From ATTWiki
(→25px FIXED: Ball Probe - Incoming Point Data) |
(→25px Other Changes) |
||
| Line 75: | Line 75: | ||
* The VTube configuration file location was changed to the more standard "c:\ProgramData\VTube" location.<br><br> | * The VTube configuration file location was changed to the more standard "c:\ProgramData\VTube" location.<br><br> | ||
* The installation performs a better job of setting up the configuration file location.<br><br> | * The installation performs a better job of setting up the configuration file location.<br><br> | ||
| − | * The Supravision network engine has been enhanced to handle data files that don't follow the Supravison spec perfectly.<br><br> | + | * The Supravision network engine has been enhanced to handle data files that don't follow the Supravison spec perfectly.<br> |
| + | * We fixed a ball probe measurement issue where VTube would sometimes not always seem to take in the single points from the FARO driver.<br><br>This issue created problems with measuring cut planes too. If you measured cut planes, and still couldn't get the cut plane to work properly, then it was probably due to this issue.<br> | ||
==Other== | ==Other== | ||
Revision as of 22:48, 16 February 2015
|
Revision 2.0
|
|
- See VTube-STEP Customer Support Page to download the latest version.
NEW: VTube Path Manager - Saves Time By Storing Important Paths
|
This change to VTube is a huge time-saver. Customers that have tested this feature report that they are very happy it. |
|
ENHANCED: SUPRAVISION NETWORK Engine Now Allows for Inverted Rotations
| The Supravision network engine now allows for rotations to be inverted for benders that have rotations that move in the opposite direction to VTube. |
|
FIXED: Ball Probe - Missing Incoming Point Data
ENHANCED: CSM and ALPINE File Data Conversions Improved
|
Other Changes
- The VTube configuration file location was changed to the more standard "c:\ProgramData\VTube" location.
- The installation performs a better job of setting up the configuration file location.
- The Supravision network engine has been enhanced to handle data files that don't follow the Supravison spec perfectly.
- We fixed a ball probe measurement issue where VTube would sometimes not always seem to take in the single points from the FARO driver.
This issue created problems with measuring cut planes too. If you measured cut planes, and still couldn't get the cut plane to work properly, then it was probably due to this issue.
Other
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER
