Difference between revisions of "VTube-LASER v2"

From ATTWiki
Jump to: navigation, search
(→‎25px NEW: Winton WMC Bender Data File Setup Window)
(→‎25px NEW: VTube Path Manager - Saves Time By Storing Important Paths)
Line 30: Line 30:
 
<td width=500>
 
<td width=500>
 
[[image:vtube-laser_2.00_WintonBenderDataSetupEditor.png|500px]]
 
[[image:vtube-laser_2.00_WintonBenderDataSetupEditor.png|500px]]
−
</td>
 
−
</tr>
 
−
</table>
 
−
 
−
 
−
===[[image:Check.jpg|25px]] NEW: VTube Path Manager - Saves Time By Storing Important Paths===
 
−
<table cellpadding=10>
 
−
<tr valign=top>
 
−
<td width=400>
 
−
This change to VTube is a huge time-saver.  Customers that have tested this feature report that they are very happy it.<br><br>
 
−
The new Path Manager allows you to store and recall complex file paths from VTube without having to constantly drill down into folders and paths.<br><br>
 
−
The window displays when you open projects and perform imports.  It also opens when you perform a Save As project.
 
−
</td>
 
−
<td width=300>
 
−
[[image:vtube-step-2_screenimage_closeup_2.png|400px]]
 
 
</td>
 
</td>
 
</tr>
 
</tr>

Revision as of 22:59, 16 February 2015

Vtube-laser logo.jpg

Revision 2.00

Vtube-laser 1.89 mainscreen.png



Check.jpg NEW: Winton WMC Bender Data File Setup Window

The new window allows VTube users to edit the data inside a Winton WMC file before exporting or adjusting a WMC file.

Vtube-laser-2.00 WintonWMC Editor Closeup.png

Vtube-laser 2.00 WintonBenderDataSetupEditor.png


Check.jpg ENHANCED: SUPRAVISION NETWORK Engine Now Allows for Inverted Rotations

The Supravision network engine now allows for rotations to be inverted for benders that have rotations that move in the opposite direction to VTube.

Vtube-2 cwrotation svnetwork.png

Check.jpg ENHANCED: CSM and ALPINE File Data Transfer Tested and Improved

  • The CSM and Alpine conversions now correctly invert the rotation value in both M3 and M4 controls - since they move in the opposite direction from VTube rotations.

  • Other adjustments and fixes to the conversion were tested with both styles of bender controls.

  • When VTube sends corrections to the M4 controls, it now changes the adjustment values rather than the nominal values in the YBC page.

Alpinebender.png



Check.jpg Other Changes

  • The VTube configuration file location was changed to the more standard "c:\ProgramData\VTube" location.

  • The installation performs a better job of setting up the configuration file location.

  • The Supravision network engine has been enhanced to handle data files that don't follow the Supravison spec perfectly.

  • We fixed a ball probe measurement issue where VTube would sometimes not always take in single points from the FARO driver. This issue created problems with measuring cut planes too. If you measured cut planes, and still couldn't get the cut plane to work properly, then it was probably due to this issue.


Other

Retrieved from "http://www.advancedtubular.wiki/index.php?title=VTube-LASER_v2&oldid=26450"