Difference between revisions of "Cable Spec 33"

From ATTWiki
Jump to: navigation, search
(CB-EL1 Board Setup For Use With Cable 33)
(Other Pages)
Line 17: Line 17:
 
The original CB-EL1 board (without jumpers) can only handle the Vector measuring center side connection.  Do not use v1 in this configuration.<br><br>
 
The original CB-EL1 board (without jumpers) can only handle the Vector measuring center side connection.  Do not use v1 in this configuration.<br><br>
 
[[image:cb-el1_bendermode.jpg|800px]]
 
[[image:cb-el1_bendermode.jpg|800px]]
 +
 +
==Breakout Tester==
 +
 +
Use a breakout tester for continuity checks like this:
 +
<br><br>
 +
[[image:cable_33_breakout_test.png|600px]]
 +
  
 
==Other Pages==
 
==Other Pages==
  
 
*[[Cable Spec]]s
 
*[[Cable Spec]]s

Revision as of 16:28, 23 August 2022

For use inside Benderlink Ethernet Modules with current loop electronics.

Cable33 closeup.jpg

Use for simulating the PREMIER (Bender) side only.

Cable33.jpg

Wiring schematic:
Cable 33 wire scheme.jpg

CB-EL1 Board Setup For Use With Cable 33

In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center. You can also use this cable to replace the current loop board at a Premier bender.

The original CB-EL1 board (without jumpers) can only handle the Vector measuring center side connection. Do not use v1 in this configuration.

Cb-el1 bendermode.jpg

Breakout Tester

Use a breakout tester for continuity checks like this:

Cable 33 breakout test.png


Other Pages