Difference between revisions of "CNC Bender v14.9-r9"
From ATTWiki
(→25px SIGNIFICANT ENHANCEMENT: Teach Mode) |
(→25px SIGNIFICANT ENHANCEMENT: Teach Mode) |
||
| Line 19: | Line 19: | ||
Teach mode is significantly enhanced:<br><br> | Teach mode is significantly enhanced:<br><br> | ||
| − | * The interface was changed to make teach mode more usable. | + | * The interface was changed to make teach mode more usable.<br><br> |
| − | * CNC Bender now warns about motion commands that were added but not actually moved during teach mode. | + | * CNC Bender now warns about motion commands that were added but not actually moved during teach mode.<br><br> |
| − | * The finish-up rotation calculations now take into account the avoidance route programmed in the Rotation options (short, long, CW, or CCW). | + | * The finish-up rotation calculations now take into account the avoidance route programmed in the Rotation options (short, long, CW, or CCW).<br><br> |
| − | * A serious memory issue was resolved. This issue could cause application error dialogs to display. | + | * A serious memory issue was resolved. This issue could cause application error dialogs to display.<br><br> |
* Steps were taken to make handling Custom Commands in the process list much faster than before. There is significantly less pause time between Custom Command steps in the process.<br><br> | * Steps were taken to make handling Custom Commands in the process list much faster than before. There is significantly less pause time between Custom Command steps in the process.<br><br> | ||
* Combined servo and non-servo motion in one Custom Command used to cause the command to pause the process if the non-servo was added first. This has been fixed. Any combination of motions in any order now works. | * Combined servo and non-servo motion in one Custom Command used to cause the command to pause the process if the non-servo was added first. This has been fixed. Any combination of motions in any order now works. | ||
<br><br><br><br> | <br><br><br><br> | ||
| − | |||
==[[image:Check.jpg|25px]] ENHANCEMENT: COMDEF Editor == | ==[[image:Check.jpg|25px]] ENHANCEMENT: COMDEF Editor == | ||
Revision as of 17:47, 23 January 2016
v14.9-r9 - January 22, 2015
|
|
SIGNIFICANT ENHANCEMENT: Teach Mode
Teach mode is significantly enhanced:
- The interface was changed to make teach mode more usable.
- CNC Bender now warns about motion commands that were added but not actually moved during teach mode.
- The finish-up rotation calculations now take into account the avoidance route programmed in the Rotation options (short, long, CW, or CCW).
- A serious memory issue was resolved. This issue could cause application error dialogs to display.
- Steps were taken to make handling Custom Commands in the process list much faster than before. There is significantly less pause time between Custom Command steps in the process.
- Combined servo and non-servo motion in one Custom Command used to cause the command to pause the process if the non-servo was added first. This has been fixed. Any combination of motions in any order now works.
ENHANCEMENT: COMDEF Editor
Custom Commands can now be loaded into the COMDEF editor to see what Processlist Builder put in them.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
