Difference between revisions of "CNC Bender v14.9-r9"

From ATTWiki
Jump to: navigation, search
(→‎25px SIGNIFICANT ENHANCEMENT: Teach Mode)
(→‎25px SIGNIFICANT ENHANCEMENT: Teach Mode)
Line 24: Line 24:
 
* A serious memory issue was resolved.  This issue could cause application error dialogs to display.<br><br>
 
* A serious memory issue was resolved.  This issue could cause application error dialogs to display.<br><br>
 
* Steps were taken to make handling Custom Commands in the process list much faster than before.  There is significantly less pause time between Custom Command steps in the process.<br><br>
 
* Steps were taken to make handling Custom Commands in the process list much faster than before.  There is significantly less pause time between Custom Command steps in the process.<br><br>
−
* Combined servo and non-servo motion in one Custom Command used to cause the command to pause the process if the non-servo was added first.  This has been fixed.  Any combination of motions in any order now works.
+
* Combined servo and non-servo motion in one Custom Command used to cause the command to pause the process if the non-servo was added first.  This has been fixed.  Any combination of motions in any order now works.<br><br>
 +
* Custom Commands that were built by Process list builder included every non-servo command twice - wasting space and time.  This has been fixed.
 
<br><br><br><br>
 
<br><br><br><br>
  

Revision as of 17:49, 23 January 2016

v14.9-r9 - January 22, 2015

Cncbender v14 logo.png


Check.jpg SIGNIFICANT ENHANCEMENT: Teach Mode

Teach mode is significantly enhanced:

  • The interface was changed to make teach mode much easier to use.

  • CNC Bender now warns about motion commands that were added but not actually moved during teach mode.

  • The finish-up rotation calculations now take into account the avoidance route programmed in the Rotation options (short, long, CW, or CCW).

  • A serious memory issue was resolved. This issue could cause application error dialogs to display.

  • Steps were taken to make handling Custom Commands in the process list much faster than before. There is significantly less pause time between Custom Command steps in the process.

  • Combined servo and non-servo motion in one Custom Command used to cause the command to pause the process if the non-servo was added first. This has been fixed. Any combination of motions in any order now works.

  • Custom Commands that were built by Process list builder included every non-servo command twice - wasting space and time. This has been fixed.





Check.jpg ENHANCEMENT: COMDEF Editor

Custom Commands can now be loaded into the COMDEF editor to see what Processlist Builder put in them.



Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v14.9-r9&oldid=28837"