Revision 2.8

Release Date: Not Released

• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)

The Default Tolerance Ends value is in the Inspection Data menu.

It allows you to set the end length default values separately from the tangent point / midpoint tolerance values.

Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.

The new commands are

• array_dev_tmt_average
  
• array_dev_tmt_maximum

See the example result in the report on the right, and the report template source to create this table shown below.

The process for corrections to Winton WMC files were clarified with dialogs that make it very clear what VTube-LASER Bender Setup is doing during the Winton WMC correction process.

1 - NEW HELP DIALOGS

Steps 2 and 5 are new. They carefully explain what is happening during the correction process.

2 - NEW BACKUP CREATED

Step 5 also explains that a BACKUP file is created during the process. This allows operators to always recover to the previous data if something goes wrong in the correction process. (The creation of a backup file is new in this version.)

Immediately after the user presses the Auto Correction button, this dialog appears (see step 2 below):

Immediately after the user presses the Exit and Save setup data button, this dialog appears (see step 4 below):

New Process Flow for Winton WMC Correction

This image shows the overall process for correction of Winton WMC files.

The Japanese translation of the UI was updated from version 2.6.

The translation includes Japanese for the Cut Plane and Diameter Cut Plane control.