Difference between revisions of "Safe Mode Motion Auto Recovery"
(→CNC Bender Upgrade) |
(→How To Get This Feature) |
||
| Line 13: | Line 13: | ||
==How To Get This Feature== | ==How To Get This Feature== | ||
| − | This feature is available on CNC Bender software versions 10-20070425 and higher. | + | This feature is available on CNC Bender software versions 10-20070425 and higher. It can be installed on older systems. The installation requires an on-site visit from an Advanced Tubular technician. Please contact either SMT or Advanced Tubular for more information about how to upgrade your benders to include this feature. |
Revision as of 22:09, 12 July 2007
Contents |
Basic Description
CNC Bender motion can recover and complete any controlled motion from any "Safe Mode Cycle Hold" state to a Cycle Start condition.
This includes Auto Mode motion, Step Mode motion, and Controlled Jog motion.
How It Works
If an operator steps on the mat in the middle of any motion, the SMT bender comes to a zero-energy state immediately. All axes are disabled. When the operator presses Cycle Start, then the bender will recover from the disabled state, re-enable the axes, calculate the remaining motion, and then complete all motion.
All Processlist Types
This is true of the primary and all secondary processlists running at the same time.
How To Get This Feature
This feature is available on CNC Bender software versions 10-20070425 and higher. It can be installed on older systems. The installation requires an on-site visit from an Advanced Tubular technician. Please contact either SMT or Advanced Tubular for more information about how to upgrade your benders to include this feature.
