Difference between revisions of "VTube-LASER v2.8.1"
From ATTWiki
(→25px NEW: UNISCAN DCF (DUAL CYLINDER FIT) Feature) |
|||
| Line 25: | Line 25: | ||
=BUILD 70 - May 6, 2017= | =BUILD 70 - May 6, 2017= | ||
| − | ==[[image:Check.jpg|25px]] NEW: | + | ==[[image:Check.jpg|25px]] NEW: END OFFSET MODEL Feature== |
<table cellpadding=10 width=900> | <table cellpadding=10 width=900> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | + | This adds a second model of the end point before it is offset.<br><br> | |
| − | + | This allows you to visually confirm that the offset point (orange) is based on the correct datum point (yellow) when a Measured offste is used, and/or a ball probe is used on the end. | |
| − | This | + | |
| − | + | ||
| − | + | ||
<td> | <td> | ||
</td> | </td> | ||
<td> | <td> | ||
| − | [[image:vtube-laser_v2. | + | [[image:vtube-laser_v2.8.1_end_offset_model.png|500px]]<br><br> |
</tr> | </tr> | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
| − | |||
=Other Pages= | =Other Pages= | ||
Revision as of 20:20, 6 May 2017
|
Revision 2.8.1Original Release Date: May 8, 2017
|
|
Contents |
BUILD 70 - May 6, 2017
NEW: END OFFSET MODEL Feature
|
This adds a second model of the end point before it is offset. |
|
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
