Revision 2.8.1

Original Release Date: May 8, 2017
Latest Build: 70 - May 6, 2017

• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• Download in updates the VTube-LASER Support Page

This adds a second end point model of the end point before it is offset.

The extra model allows you to visually confirm that the offset point (orange) is based on the correct datum point (yellow) when a Measured offste is used, and/or a ball probe is used on the end.

In the top image on the right, the yellow ball represents the middle of the ball probe. The orange ball is the projected end point based on the compensation toward the end.



When the two points are within 0.1 mm (0.0039 inches) of within each other, then VTube only draws the final orange ball.

As of this version if VTube-LASER toggles from LASER to ball probe or ball probe to LASER, it notifies you with a sound and a guide box message.

As of this version if VTube-LASER allows you to toggle UNISCAN to MULTISCAN and back in the SAME tube.

In previous versions, this was not easy to do because the measure setup was good for either UNISCAN or MULTISCAN - but not both. Now VTube included separate setup values in the Measure Setup LASER tab for UNISCAN or MULTICAN. Also, the Separation filter menu has separate values for both UNISCAN and MULTISCAN.

The reason we added this feature is because some tubes have bowed straights that can only be measured with MULTISCAN. (See video 67 in VTube-LASER Videos).

• We increased the volume of the scanning sound so that it is easier to hear in factory environments.
  
  
• We fixed a bug in DIAMETER Multiscan.
  
  
• We removed two unneeded internal checks in DCF (Diameter Cut Plane) that were redundant. (Vector angle check and offset at a distance check).