Difference between revisions of "Benderlink Module - Laservision to Crown"
| Line 13: | Line 13: | ||
[[image:cb-el1_render1.jpg|right|250px]] | [[image:cb-el1_render1.jpg|right|250px]] | ||
Advanced Tubular uses a special board designed to allow communications with Eaton Leonard Laservisions and benders. See [[Communications Board for Eaton Leonard - CB-EL1]] for detailed information on our electronics. | Advanced Tubular uses a special board designed to allow communications with Eaton Leonard Laservisions and benders. See [[Communications Board for Eaton Leonard - CB-EL1]] for detailed information on our electronics. | ||
| + | |||
| + | ===Installation on Crown Bender=== | ||
| + | This is an image of the same box installed on a Crown bender control. | ||
| + | [[image:Blinkmodule_crown.jpg|300px| | ||
| + | |||
| + | |||
Revision as of 21:53, 10 September 2007
This version of the Benderlink Module connects Eaton Leonard Laservision legacy electronics (commonly called "current loop") to a Crown Unlimited bender.
This model was designed to connect two Laservision measuring centers to one Crown bender. The two Amphenol circular ports use the Eaton Leonard communications cable standard. The ports are switched using an industrial AB switch embedded into the Benderlink module.
CB-EL1 Electronics Board
Advanced Tubular uses a special board designed to allow communications with Eaton Leonard Laservisions and benders. See Communications Board for Eaton Leonard - CB-EL1 for detailed information on our electronics.
Installation on Crown Bender
This is an image of the same box installed on a Crown bender control. [[image:Blinkmodule_crown.jpg|300px|
See Also
This module works with Benderlink for Crown software.
