Difference between revisions of "VTube-LASER Near Pass Deviation"
From ATTWiki
(→How To Change the Tolerance) |
(→How To Change the Tolerance) |
||
| Line 54: | Line 54: | ||
<tr> | <tr> | ||
<td width=300 valign=top> | <td width=300 valign=top> | ||
| − | You can | + | You can change the tolerance when measuring by pressing the gear button at the top of the Cylinder Fit Data window. |
</td> | </td> | ||
<td> | <td> | ||
Revision as of 14:35, 17 September 2018
|
|
|
Nearest Pass Explanation
|
The point at which two 3D lines are the closest to each other is where they come closest to intersecting. The distance is the “nearest pass.” |
|
How it is used in VTube-LASER
|
VTube-LASER checks for and displays the Nearest Pass value when measuring two intersecting tube straights. If the value is too high, then VTube-LASER will ask you to remeasure the tube until the value is within tolerance. The default tolerance for Nearest Pass is 2mm. |
|
How To Change the Tolerance
|
You can change the tolerance by entering System Options, Measure 1 menu and changing the Maximum Near Pass Deviation Allowed value. |
|
|
You can change the tolerance when measuring by pressing the gear button at the top of the Cylinder Fit Data window. |
|
