Difference between revisions of "CNC Bender v10-20070914"
From ATTWiki
(→IMPROVED: MASTER Folder Protected from Part Load) |
(→Solution To Issue) |
||
| Line 27: | Line 27: | ||
<ul> | <ul> | ||
| − | This version | + | This version patiently waits for CNC Processor to switch to MANUAL mode before attempting to build the process list. |
<br><br> | <br><br> | ||
| Line 36: | Line 36: | ||
<br><br> | <br><br> | ||
| − | |||
=IMPROVED: MASTER Folder Protected from Part Load= | =IMPROVED: MASTER Folder Protected from Part Load= | ||
Revision as of 22:59, 20 September 2007
Contents |
IMPROVED: Improved Auto Build during AUTO MODE
Explanation
- CNC Bender automatically switches from Auto Mode to Manual Mode during the Auto Build process.
- There was a possibility that the process list builder would attempt to build a process list even though CNC Bender had not switched to MANUAL mode.
- This situation would cause errors or lockups.
Solution To Issue
-
This version patiently waits for CNC Processor to switch to MANUAL mode before attempting to build the process list.
IMPROVED: MASTER Folder Protected from Part Load
Explanation
- CNC Bender would allow a user to switch from the PARTS folder to the MASTER folder while loading parts, thus bypassing the password entry box.
Solution To Issue
-
This version will no longer allow access to the MASTER folder from the PARTS LOAD or SAVE dialogs.
How to UPGRADE
If your operator station contains one of the versions listed below, then they can be upgraded through simple self-installation:
Please contact Advanced Tubular Technologies for upgrade information.
