Difference between revisions of "Bender Rotation Directions"
From ATTWiki
| Line 8: | Line 8: | ||
<table> | <table> | ||
| + | |||
<tr> | <tr> | ||
<td> | <td> | ||
| Line 26: | Line 27: | ||
</td> | </td> | ||
</tr> | </tr> | ||
| + | |||
| + | <tr> | ||
| + | <td> | ||
| + | European and Asian benders usually follow the LEFT-HAND rule - which means that positive rotates CW. (To prove this, hold your left hand so that your thumb is pointing at you. What direction do your fingers curl?) | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:bobcad_lefthand_rule.png|400px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | |||
</table> | </table> | ||
<br><br> | <br><br> | ||
| − | |||
| − | |||
Revision as of 01:37, 30 March 2021
The "positive" direction for rotations in benders is NOT standardized. It is important to understand how to determine rotation directions to avoid confusion through mirror-imaging parts accidentally.
- The direction of rotation can be indicated with a CW or CCW direction of rotation from the viewpoint of a viewer at the front of a bender looking toward the rear of the bender.
- When a bender collet rotates CCW to rotate positive, then it uses the American industry standard, the standard for our VTube software. In this case, +90 would rotate the chuck 90 degrees CCW.
- When a bender collet rotates CW to rotate positive, then it uses the non-American industry standard, the opposite of the VTube software. In this case, +90 would rotate the chuck 90 degrees CW.
The engineering community uses a simple right-hand/left-hand rule to designate which way an axis spins positive.
|
This BobCAD-CAM illustration demonstrates the RIGHT-HAND rule. In this "right-hand rule" illustration:
|
|
|
European and Asian benders usually follow the LEFT-HAND rule - which means that positive rotates CW. (To prove this, hold your left hand so that your thumb is pointing at you. What direction do your fingers curl?) |
|
