Difference between revisions of "Feed-Bend Motion Adjust Percent"

Feed-Bend Motion Adjust %

Floating Point Value

Using a Value of ZERO

A value of ZERO will cause no adjustment in the Feed motion during Feed Bending.

Using a Value BELOW ZERO

For example, enter -5 (negative 5) to adjust the Feed motion during Feed bending by negative 5 percent.

Use this value will accomodate for...

1. Extreme elongation that cause the Feed axis to jump after the motion is complete and the bend dies open. (Larger/stiffer tubes)
2. Bowing of the smaller diameter tubes.

Decreasing the value too much will likely cause the tube to pull from the chuck.

Using a Value of ABOVE ZERO

For example, enter 5 (positive 5) to move 5 percent further during Feed Bending..

Increasing the value too much will cause the Feed to attempt to press further for final position, not allowing it to come into position.