Difference between revisions of "Revision: Benderlink for BLM 3.2"
From ATTWiki
(→Other Pages) |
|||
| Line 55: | Line 55: | ||
<br><br> | <br><br> | ||
| − | + | ==Other Pages== | |
| − | + | ||
| − | + | *Go back to [[Benderlink]] | |
| + | *Go back to [[Benderlink for BLM]] | ||
| + | *Go to the [http://www.advancedtubular.com/blink_blm.htm main Benderlink for BLM page] | ||
| + | *About [[BLM]] Group U | ||
Revision as of 04:08, 12 February 2009
New Recognition of Variable Radius Bending
|
BLM benders can bend using rotary draw bending or push-roll bending. BLM refers to push-bending as "variable radius bending." This version of Benderlink can recognize large radius push-bends and skip corrections to straights before and after push-bends. Also the bend angle of each push-bend is left untouched. |
|
Benderlink indicates which values are not corrected by showing a bold red value on the screen. The BLUE radius values indicates the Benderlink knows that variable radius bending is in effect. |
|
Set the Linear Units for Conversion
|
Benderlink now shows two radio-buttons in the Measuring Center section that allow the operator to send the data to the measuring center in a consistent unit value. |
|
Adjusted the BLM Data Output Accuracy
| Bender data was being output as integer data. |
The precision is now set to four places beyond the decimal. |
Other Pages
- Go back to Benderlink
- Go back to Benderlink for BLM
- Go to the main Benderlink for BLM page
- About BLM Group U
