Difference between revisions of "Push Bending Profile Table"
From ATTWiki
(→Description of Values) |
(→Description of Values) |
||
| Line 15: | Line 15: | ||
==Description of Values== | ==Description of Values== | ||
| − | {| border="1" cellpadding="5" cellspacing="0" align="none" width= | + | {| border="1" cellpadding="5" cellspacing="0" align="none" width=500 |
|+'''Description of Profile Setup Values in CNC Bender''' | |+'''Description of Profile Setup Values in CNC Bender''' | ||
|- | |- | ||
| Line 43: | Line 43: | ||
|+''Sample Profile Table'' | |+''Sample Profile Table'' | ||
|- | |- | ||
| − | + | | [[image:Cncbender_v11_profiletable.png|500px]] | |
|} | |} | ||
|} | |} | ||
Revision as of 19:53, 25 April 2008
Contents |
About Push Bend Profile Tables
This is a sample Push Bend Profile Table. Each profile row contains a profile setup for a given radius. An unlimited number of profile values can be entered. Using this method of calculation, it is possible to calculate different Push Bends by indicating the new bend angles.
Because we use this method of calculation, it is possible to correct push bent parts using measuring center connections. Correct the bend value, and the push bend values are automatically calculated during AutoBuild.
Description of Values
| Value Name | Description | ||
|---|---|---|---|
| Profile Name | The name is how the profile is displayed and selected in the Bend Options. | ||
| Arm Angle | This is the final angle of the arm during push-bending. | ||
| Arm vAdjust | This allows the velocity of the bend arm to be adjusted by a percentage of the original calculated velocity. | ||
| Feed Position | This is how far the carriage must travel to achieve the "@ Degrees" value. | ||
| Feed Velocity | This is the velocity of the carriage during the bend. The velocity of the carriage is used to calculate a starting bend arm motion speed. | ||
| @ Degrees | This is the angle of the tube that is achieved by the "Feed Position" value above. | ||
| |||
Other Pages
See CNC Bender v11-20080424 for information on the first version to enable Push Bending
