Difference between revisions of "Benderlink for Pines"
(→TS-2000 Control to Vector 1 Laservision) |
(→TS-2000 Control to Vector 1 Laservision) |
||
| Line 12: | Line 12: | ||
[[Image:EL Laservision Tube Data Center.jpg|right]] | [[Image:EL Laservision Tube Data Center.jpg|right]] | ||
The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.<br><br> | The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.<br><br> | ||
| + | |||
| + | |||
| + | <br><br> | ||
| + | <br><br><br><br> | ||
=Versions= | =Versions= | ||
Revision as of 00:52, 1 May 2008
Contents |
About
Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers.
TS-2000 Control to Vector 1 Laservision
The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.
Versions
Version 1.0
Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.
Version 2.0
Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.
