Difference between revisions of "CNC Bender v11-20090126"
| Line 5: | Line 5: | ||
| + | ===[[image:Check.jpg|25px]] NEW - SAVE and LOAD Tool Set Files from the Tool Page === | ||
| + | |||
| + | The tool page now has load and save buttons for TOOL SET FILE management in CNC Bender. | ||
| + | <br><br> | ||
| + | |||
| + | [[image:cncbender_new_loadsave_file_toolpage.jpg|500px]] | ||
| + | <br><br> | ||
===[[image:Check.jpg|25px]] ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits === | ===[[image:Check.jpg|25px]] ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits === | ||
Revision as of 16:28, 28 January 2009
NEW - SAVE and LOAD Tool Set Files from the Tool Page
The tool page now has load and save buttons for TOOL SET FILE management in CNC Bender.
ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits
The Low Level names of dynamic options "Feed Torque Safe High" and "Feed Torque Safe Low" were adjusted for clarification.
The new names include "Feed-Bend" inserted in the beginning to be sure users understand that these values are used by the Processlist Builder to limit the feed axis torque during Feed-Bending only. These values have no effect on the torque of the feed axis for any other type of feed motion.
These are the options before the change:
These are the options after the change:
Upgrade Note: When upgrading to this version, it is important to remember to restore the dynamic options in low level in order to see this change take effect.
WARNING: Be Careful to Set Proper Torque Limits
|
|
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
