Revision as of 20:31, 28 January 2009

CNCProcessor.cfg File

The CNC Processor configuration file contains the values necessary to adjust the machine lube settings.

Where to find it in CNC Bender

The configuration is displayed in an editor in the Low Level menu, CNC Processor CFG tab.

If you edit the values in this editor, be sure to keep the equals signs in the setup, and be careful to enter valid values. For example, for duration values, enter only whole numbers (no text).

Then save the data to disk in order to store the changes made.

Where to find it on the Hard Disk

The file is available in the c:\cnc\config folder in the file "CNCProcessor.cfg". A text editor can be used to change the file. Only change the file this way when CNC Bender is closed.

"Machine Lube" Section

The settings in this file are separated by sections with section names in square brackets like this:

[Machine Lube]
Machine Lube Duration=5000
Lube Machine At Bend Count=100
Pulse Machine Lube Pump=1
Watch For Machine Lube Complete Input=0

The four values above control the machine lube features in CNC Bender.

Machine Lube Duration

• Read how to set the Machine Lube Duration

Lube Machine At Bend Count

• Read how to set the Lube Machine At Bend Count

Pulse Machine Lube Pump

• Read how to set the Pulse Machine Lube Pump

Watch For Machine Lube Complete Input

• Read how to set the Watch For Machine Lube Complete Input

Other Pages

Back to