Difference between revisions of "Pulse Machine Lube Pump"
From ATTWiki
(→How to Determine if the System Should Use Pulse) |
(→How to Determine if the System Should Use Pulse Output) |
||
| Line 21: | Line 21: | ||
<td width=300 bgcolor="#f0f0f0"> | <td width=300 bgcolor="#f0f0f0"> | ||
<font size=5>[[image:Gear_warning.jpg]] <b>WARNING!</b><br><br></font> | <font size=5>[[image:Gear_warning.jpg]] <b>WARNING!</b><br><br></font> | ||
| − | <font size=3>'''Do not''' use PULSE setting for lube systems with electric motors.<br><br> | + | <font size=3>'''Do not''' use PULSE setting for lube systems with '''electric motors'''.<br><br> |
Switching the electric-motor pump on and off with pulsing may damage the motor and possibly void the warranty. | Switching the electric-motor pump on and off with pulsing may damage the motor and possibly void the warranty. | ||
</font></td></tr></table> | </font></td></tr></table> | ||
Revision as of 21:26, 28 January 2009
Pulse Machine Lube Pump
What is It?
This is a boolean (on/off) property in the CNCProcessor.cfg file. It is a switch that instructs CNC Processor to pulse the lube actuator during a machine lube event.
Value
The value is set to either 0 (for off) or 1 (for on).
Pulse Machine Lube Pump= 1
How to Determine if the System Should Use Pulse Output
Only use pulse for lube systems that use a pneumatic valve to send lube oil throughout the machine. It is very important to set pulse OFF (0) if your machine uses an electric motor for its lube system.
|
|
Other Pages
- Back to CNC Bender Technical Notes
- See Auto Lube for details on how to test the Auto Lube system
- See Configuring Machine Lube Settings
- See CNCProcessor.cfg
