Difference between revisions of "CNC Bender v11-20090408"
| Line 14: | Line 14: | ||
<br><br> | <br><br> | ||
| − | ===[[image:Check.jpg|25px]] CHANGE - Mandrel Early Advance in Prebend === | + | ===[[image:Check.jpg|25px]] CHANGE - Mandrel Early Advance in Prebend Logic === |
If ENABLED, this command is now SKIPPED if there the MANDREL CYLINDER ENABLE is OFF in the first bend.<br><br> | If ENABLED, this command is now SKIPPED if there the MANDREL CYLINDER ENABLE is OFF in the first bend.<br><br> | ||
Revision as of 08:49, 8 April 2009
ENHANCED - Moved MANDREL CYLINDER ENABLE option from OVERALL to BEND Rows
This change allows the mandrel to be switched ON or OFF individually for any bend row rather than for every bend row.
This new feature is critical for mandrels in rectangular or square tubing that rotate 90 degrees, but the mandrel can only bend in one of the two planes.
CHANGE - Mandrel Early Advance in Prebend Logic
If ENABLED, this command is now SKIPPED if there the MANDREL CYLINDER ENABLE is OFF in the first bend.
ENHANCED - RADIUS SHIFTING OFF - NO Radius Motion
|
When Radius Shifting is OFF in the TOOL page, then CNC Bender will no longer, under any circumstance shift the horizontal or carriage axis. We believe that this will be useful because when shifting is OFF, the motion should be completely manually controlled and only manually controlled. |
|
ENHANCED - SQUARE TUBE & ABSOLUTE ROTATION Feature - AUTOMATIC RADIUS SHIFT AWAY
|
The Absolute Rotation features in PREBEND will always bring the rotation axis back to an absolute position when moving to the LOAD position. Then, after the tube is chucked, the rotation spindle will rotate the tube to an offset position. If the tube is square, then CNC Bender will automatically perform a Radius Shift Away motion to keep the square tube from catching in the die - even if the Start - Radius Shift Away option is set to OFF. |
|
REPAIR - START Rotation ENABLES in PREBEND only if AVAILABLE (LITECONTROL)
| For LiteControl, the START ROTATION value in the PREBENDING page now only enables if the option is active in LiteControl. |
|
ENHANCE - SINGLE INSTANCE CONTROL is Now Completely AUTOMATIC
CNC Bender only allows for one instance in memory at a time. However, it used to display a message in a dialogue box if multiple instances were attempted.
We found this message to be annoying and unnecessary - so it is completely removed. Now the first instance of the program is quietly given focus if an operator accidentally loads the software twice.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
