Difference between revisions of "Overbend Calculator"
From ATTWiki
(→Download Page) |
|||
| Line 2: | Line 2: | ||
<tr> | <tr> | ||
<td>[[image:overbend_calculator_splash.jpg|300px]]</td> | <td>[[image:overbend_calculator_splash.jpg|300px]]</td> | ||
| − | <td>Reduce Scrap & Save Material | + | <td><font size=4>Reduce Scrap & Save Material |
| − | by Predicting Springback BEFORE Bending the Part</td> | + | by Predicting Springback BEFORE Bending the Part</font></td> |
</tr> | </tr> | ||
</table> | </table> | ||
Revision as of 18:51, 16 May 2009
 |
Reduce Scrap & Save Material by Predicting Springback BEFORE Bending the Part |
This is software that calculates overbend necessary to overcome springback in bends.
Three Step Process for Predicting Springback
- STEP 1: Two test bends are made. Typically they are 20 and 120 degrees. The bender is set to bend these angles and a test tube is bent.
- STEP 2: The actual resulting bend angles are measured and entered into the overbend calculator.
- STEP 3: Two values called "proportional" and "fixed" are calculated and used in a springback formula to predict overbend to overcome springback at any angle.
Download
Download Overbend Calculator 30-day Trial Package (Shareware)
