Difference between revisions of "Overbend Calculator"
From ATTWiki
(→Other Pages) |
(→Other Pages) |
||
| Line 31: | Line 31: | ||
==Other Pages== | ==Other Pages== | ||
| − | *[http://advancedtubular.com/ovbend.htm Main Overbend Web Page | + | *[http://advancedtubular.com/ovbend.htm Main Overbend Calculator] Web Page |
*Purchase an Activation Code: [http://www.advancedtubularstore.com/servlet/the-53/Overbend-Calculator-v7--dsh-/Detail Online Store - Overbend Calculator] Page | *Purchase an Activation Code: [http://www.advancedtubularstore.com/servlet/the-53/Overbend-Calculator-v7--dsh-/Detail Online Store - Overbend Calculator] Page | ||
Revision as of 18:54, 16 May 2009
 |
Reduce Scrap & Save Material by Predicting Springback BEFORE Bending the Part |
This is software that calculates overbend necessary to overcome springback in bends.
Three Step Process for Predicting Springback
- STEP 1: Two test bends are made. Typically they are 20 and 120 degrees. The bender is set to bend these angles and a test tube is bent.
- STEP 2: The actual resulting bend angles are measured and entered into the overbend calculator.
- STEP 3: Two values called "proportional" and "fixed" are calculated and used in a springback formula to predict overbend to overcome springback at any angle.
Download
Download Overbend Calculator 30-day Trial Package (Shareware)
Other Pages
- Main Overbend Calculator Web Page
- Purchase an Activation Code: Online Store - Overbend Calculator Page
