Difference between revisions of "CNC Bender v11-20091007"
| Line 6: | Line 6: | ||
===[[image:Check.jpg|25px]] NEW - Low Level - Rotate Reset Mode === | ===[[image:Check.jpg|25px]] NEW - Low Level - Rotate Reset Mode === | ||
| − | The Rotate Reset Mode controls if the rotate axis is reset to zero between every bend by default. If you intend to use Absolute Pre-Rotate Enable with multiple parts in the Runlist, and the axis should never reset itself except when homing, then the Rotate Reset mode can be set to DISABLE | + | The Rotate Reset Mode controls if the rotate axis is reset to zero between every bend by default. If you intend to use Absolute Pre-Rotate Enable with multiple parts in the Runlist, and the axis should never reset itself except when homing, then the Rotate Reset mode can be set to DISABLE. |
<br><br> | <br><br> | ||
The default mode is ENABLED. | The default mode is ENABLED. | ||
| − | |||
===[[image:Check.jpg|25px]] NEW - Separate Part Release Mandrel Retract Command for Faster Cycles === | ===[[image:Check.jpg|25px]] NEW - Separate Part Release Mandrel Retract Command for Faster Cycles === | ||
Revision as of 12:55, 7 October 2009
NEW - Low Level - Rotate Reset Mode
The Rotate Reset Mode controls if the rotate axis is reset to zero between every bend by default. If you intend to use Absolute Pre-Rotate Enable with multiple parts in the Runlist, and the axis should never reset itself except when homing, then the Rotate Reset mode can be set to DISABLE.
The default mode is ENABLED.
NEW - Separate Part Release Mandrel Retract Command for Faster Cycles
A Mandrel Retract Part Release command is added to separate it from all other Mandrel Retraction commands.
Since this feature allows CNC Bender to treat the last mandrel retraction separately from the in-bend mandrel retractions, you can increase a pause in the command after the final mandrel retraction while decreasing or eliminating the pauses or prox. switch examinations in the in-bend mandrel retractions - thus shaving cycle time.
|
In-Bend Mandrel Retract Command |
MandrelRetract |
|
New Part Release Mandrel Retract Command |
MandrelRetract_PartRelease |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Absolute Rotate
- See Absolute Rotate Offset Position
- See Final Feed Clearance
- See Mandrel Retract
- See Mandrel Retract Part Release
