Difference between revisions of "CNC Bender v11-20091104"
From ATTWiki
| Line 11: | Line 11: | ||
<tr> | <tr> | ||
<td width=300> | <td width=300> | ||
| − | * The final bend arm return motion now allows logic to | + | * The final bend arm return motion now allows following process list logic to begin even if the bend arm is still returning home.<br><br> |
* The Bend Return Step Point value in the last row controls when the final bend arm return will release the processlist to move back to the beginning of the program. | * The Bend Return Step Point value in the last row controls when the final bend arm return will release the processlist to move back to the beginning of the program. | ||
| Line 24: | Line 24: | ||
<br><br> | <br><br> | ||
| − | |||
===[[image:Check.jpg|25px]] NEW - New Optimization in Processor - Makes Bender Run Faster=== | ===[[image:Check.jpg|25px]] NEW - New Optimization in Processor - Makes Bender Run Faster=== | ||
Revision as of 22:24, 4 November 2009
NEW - Final Bend Simultaneous Motion
|
|
NEW - New Optimization in Processor - Makes Bender Run Faster
|
|
NEW - HIGH SPEED Constant Run List
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Absolute Rotate
- See Absolute Rotate Offset Position
- See Final Feed Clearance
- See Mandrel Retract
- See Mandrel Retract Part Release
