Revision as of 22:38, 23 November 2009

Type of Upgrade: FLEXIBILITY

The changes in this version are additions to CNC Bender for better editing and reporting.

The new editor in Low Level allows you to edit the new High Speed Constant Run Processlist.

Both of these commands can now be named in the General Dynamic Option List in Low Level.
Automated logic has been installed to work like this:

...then AllDiesToHomeWithoutPDA is called immediately after in order to insure that the pressure die and clamp dies are home before continuing.

...then AllDiesToHome is called to be sure the pressure die, clamp die, and Pressure Die Assist die are home before continuing.

@@ Line 60: / Line 60: @@
 </table>
-===[[image:Check.jpg|25px]] REPAIR - Feed Move into Interference Zones for AFTER Check for PD (Pressure Die) HOME ===
+===[[image:Check.jpg|25px]] UPDATE- Improved Grids in Dynamic Option Lists ===
 <table>
 <tr valign=top>
 <td width=300>
-* CNC Bender now properly checks for the PD HOME switch activated before ATTEMPTING to move the FEED axis into the interference zone<br><br>
+* New grid source with improvements.
-* Previous versions could skip the wait for the PD motion to complete, then give a collision error by not waiting for the PD to move home.<br><br>
-* This prevents the following type of error:<br><br>
 </td>
 <td width=300>
-[[image:feedaxis_icon.jpg]]<br><br>
+[[image:optionslists.jpg|400px]]
-----------------------------------------
-/17/2009 2:50:19 PM
-Collision - The Pressure Die Is Not Home And Feed Would Have Penetrated the Pressure Die Interference Zone, CIO Checked: Input_PressureDieIsHome_End
-----------------------------------------
 </td>
 </tr>

Difference between revisions of "CNC Bender v11-20091123"