Revision as of 03:42, 2 December 2009

Type of Upgrade: FLEXIBILITY

The changes in this version are changes to CNC Bender for better flexibility.

CNC Bender now allows logic to make a physical momentary push-button into a toggle switch. For example, push the button to switch a state on, then push it again to switch the state off.

For example, it is possible to use logic in the Constant Run processlist to switch a End Cycle ON and OFF using a push button.
It is also possible to illuminate the button according to the current End Cycle state.

Edge triggers now reset properly when repeating the same inputs in multiple [IF] and [IFNOT] commands in the list of commands.

If an edge triggerized input is true in an IF line, then the edge trigger is CLEARED - UNLESS the entire set of logic in that parameter line returns FALSE as a whole. In that case the edge trigger is set back to TRUE (it is SET).

This allows for multiple uses of the same input in processlists - like in the Constant Run processlist.

The part count updated normally except when the Runlist Run is complete. This is corrected.

@@ Line 51: / Line 51: @@
 <tr valign=top>
 <td width=300>
-* Edge triggers now work when repeating the same inputs in multiple [IF] and [IFNOT] commands in the list of commands.<br><br>
+* Edge triggers now reset properly when repeating the same inputs in multiple [IF] and [IFNOT] commands in the list of commands.<br><br>
 * If an edge triggerized input is true in an IF line, then the edge trigger is CLEARED - UNLESS the entire set of logic in that parameter line returns FALSE as a whole.  In that case the edge trigger is set back to TRUE (it is SET).<br><br>

Difference between revisions of "CNC Bender v11-20091201"